The official download for the MKS Laser Tool Setup V1.1.2.exe is typically hosted on the Makerbase MKS-DLC32 GitHub repository
Verify that the GRBL settings match your machine setup. You can type $$ into the console command line within the tool to read your current machine configurations and ensure step limits and laser mode ( $32=1 ) are correctly enabled. Conclusion
Easily update or change your GRBL firmware without compiling source code. Mks Laser Tool Setup V1.1.2.exe Download
Connect your engraver to your local network without needing a physical touchscreen, enabling wireless control via mobile apps or web browsers.
The software has three main components:
If the laser begins cutting but shuts off after a short time, this may be a hardware configuration issue rather than a software problem. One known issue involves the P‑DA‑01 driver: when connected, the laser shuts off completely after 1–2 seconds. Disconnecting that driver and connecting the laser directly to the MKS DLC32 TTL output has resolved this for some users.
Click . The board will store these credentials and display its assigned IP address on its TS35/TS24 screen or return it via the console. 3. Laser Image Tool The official download for the MKS Laser Tool Setup V1
Connect your engraver to your network to use wireless apps or web interfaces. Connect to the board via USB first.
I can give you specific troubleshooting steps for your exact setup. Share public link Connect your engraver to your local network without
Ultimate Guide to Makerbase MKS Laser Tool V1.1.2 Setup The is a proprietary software utility developed by Makerbase. It is designed to configure, control, and flash firmware onto Makerbase laser engraving control boards, such as the MKS DLC32 series. 🛠️ Key Features of MKS Laser Tool V1.1.2
This usually means your PC lacks the necessary USB-to-Serial drivers. The MKS DLC32 uses the CH340 chip. Download and install the CH340/CH341 USB driver to resolve this.